What level should I set my shock collar?
With the Collar Receiver turned on and properly fitted to your dog, set the Remote Transmitter’s Intensity Dial at Level 1 and press the Continuous Stimulation Button for 1 to 2 seconds. If your dog shows no reaction to Level 1, go to Level 2 and repeat the process.
How do you use an electric collar?
Here are the steps that we recommend for using a shock collar as a training tool.
- Purchase a Quality Product.
- Start with the basics.
- Let your dog get used to the collar first.
- Show your dog the behavior you want.
- Back-up the shock collar with other techniques.
- Aim to use “vibrate” or no collar at all.
What do the buttons on the e-collar do?
1) Stimulation Button – (Black) It sends a stimulation to collar. 2) Stimulation Booster Button – (Red) It sends a boosted stimulation to collar (25 levels higher than current stim level). Depending on your dog, this might be used as the corrective level.
How do you start training collars?
To do this you begin with the stimulation set at zero on the remote, fit the collar properly on your dog’s neck and let your dog explore the training area. Once he is engaged and not focused on you, begin tapping on the stimulation button while very slowly increasing the level.
What is a good shock level for dogs?
The level that a shock collar should be on is the one that gets your dog’s attention. You aren’t trying to make them freeze in their tracks or scream in pain. You are trying to get their attention so that they will stop what they are doing and pay attention to you.
What voltage should my dogs shock collar be?
1500 volts to 4500 volts
The collar is fit on the dog so the electrodes penetrate the dog’s fur and press directly against the dog’s skin. When activated, there is a potential of 1500 volts to 4500 volts across the electrodes, which delivers a painful electrical shock to the dog1. Some collars may even operate at higher voltages.
Why is my e collar not working?
Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.
Why is my e-collar not working?
What is M and C on e-collar?
Momentary/Continuous Button “M/C” – M/C Button on the backside of the transmitter allows the user to easily switch between the three stimulation modes. – Momentary Mode : Stimulation Button “S” and Stimulation Booster Button “S” will send Momentary Stimulation.
What is the red button on the e-collar?
continuous pressure
There are several parts of the e-collar: the red button is the continuous pressure, the black “nick” button above continuous is for quick bursts of stimulations , the dial turns up and down the amount of stimulation, and the T is the vibrate function. If you are using the EC-300 the T can also be utilized as a tone.