How do I reset my rain dial timer?

How do I reset my rain dial timer?

Open the battery compartment and disconnect the battery. Press and hold the Manual button in and KEEP HOLDING IT IN while performing the next step. Reconnect the ribbon cable, then release the Manual button. Note: The display should now show 12:00 AM indicating the controller has reset.

How do you reset a sprinkler system?

  1. Turn the control dial to the “off” position.
  2. Press the “next” button to access the clear-memory feature.
  3. Press and hold the “off” button until the display stops blinking.
  4. Turn the control dial to the “run” position.
  5. Press and hold down the “minus” arrow and “prog” buttons simultaneously.

Why is my rain dial not working?

Disconnect power from the timer, open the timer controller door and open the control module from its right edge. Examine the fuse at the top of the PC board to confirm whether or not it’s blown. If the fuse is blown, remove it from the retaining clip and reinsert a new 2.0A slow blow fuse. Reconnect power to the timer.

Why is my sprinkler system not coming on?

The most common cause of individual sprinklers not coming on is blockage. The thin spray opening of a sprinkler head easily becomes clogged with dirt and debris. Inspect malfunctioning sprinkler heads while the water supply is off, and clear blockages with a thin, straight-edged tool such as a screwdriver.

How do I turn on Irritrol valves?

There are 2 simple methods to open the valve manually: To open the valve manually, twist the manual bleed screw counter-clockwise until the valve opens. It usually doesn’t need to be more than one-half turn. To close the valve turn the manual bleed screw clockwise until the valve closes.

How do I reset my rain dial controller?

Why is my sprinkler controller not working?

If the system doesn’t seem to be running, check that the controller is set to auto or run. Remember: while scheduled settings may be programmed, they are not activated until the controller is set to auto. If you see that the controller is set to run, the start time may not have been saved.