What is a wash down switch?
Typical Use for a Wash Down Rocker Switch: Use this switch to power your wash down pump. This pump is often a constant pressure pump that goes to a hose on your deck, so you can clean the sand, mud, fish guts, etc off your beautiful white fiberglass.
What is wash down on boat?
A washdown system helps you clean up the boat after a day on the water. An onboard washdown system provides a convenient means to hose down the deck after a day of boating.
How do you install a wash down pump on a boat?
Locate and mount the washdown pump in a dry location in the bilge up to six feet from the raw-water intake, but be sure to allow sufficient room to place the raw-water strainer on the inlet side of the pump. For extra-quiet operation, insert a 1/8- to ¼-inch rubber gasket between the pump and the bulkhead.
What is raw water washdown on a boat?
That is a raw water (which is the water directly below your boat) washdown connection. A pump pumps raw water to it. A hose is generally attached to it. The valve is to shut it off when you are through using it so the pressure sensative pump does not continue to run.
How does washdown pump work?
Many washdown pumps incorporate some sort of solenoid, or pressure switch. As soon as the trigger is pulled on the end of the hose, the resultant drop in pressure is sensed, which turns on the pump. This serves two purposes: First, the pump only runs when water is required.
Can I add a float switch to a bilge pump?
The addition of a float switch to a bilge pump circuit allows the bilge pump to come on automatically once the water in the boat reaches a certain level. This ensures that even if there is nobody on the boat to turn on the bilge pump, it will still pump water out of the boat.
What is a washdown system for boats?
How many GPM is a washdown pump?
3.0 Gallons per Minute
3.0 GPM Washdown Pump, 12V
| Amperage | 8 Amps at 12 Volts |
|---|---|
| Capacity | 3.0 Gallons per Minute |
| Diameter | 3/4 Inch |
| Dimensions | 4.25″ Width x 4.75″ Height x 9″ Length |
| Material | Polypropylene EPDM Valves Santoprene Diaphragm |
Does a bilge pump need a fuse?
The pump must be connected to a power source such as a battery. In wiring and fitting of an automatic bilge pump, it is essential to provide a fuse. The latter, which is contained in a fuse holder, is actually a safety device for the wires of your bilge pump and therefore components in general.
How many amps does a washdown pump draw?
A washdown pump can draw 10 amps or more, which can dangerously overload a lighting circuit. The safest course is a dedicated circuit with a new fuse or breaker in the main electrical panel.