Are Brother TZ and TZe tapes the same?
What is Brother’s new TZe tape? They are the same durable TZ labels you’re accustomed to but now with new packaging that features: Eco-friendly – using 80% less plastic than before!
Why is my brother label maker not working?
If your label maker won’t turn on, you should make sure the batteries are not dead or about to run out. Replace the old batteries with six new AAA batteries. Make sure you replace them properly using this Battery Replacement Guide. Check the upper battery terminals.
Why is my P-touch label maker not working?
Replace the batteries with six new AAA alkaline batteries (LR03) or fully charged Ni-MH batteries (HR03). The P-touch resets to the default setting when more than 3 minutes pass after the batteries are removed, or the P-touch is disconnected from the AC adapter without using batteries.
How do I reset my Brother P-touch label maker?
FAQs & Troubleshooting
- Turn off the P-touch.
- Hold down the “Shift” and the “R” keys.
- While holding down the “Shift” and the “R” keys, press the “On/Off” key or Power key once and then release the “Shift” and the “R” keys.
- “English” should be on the display. The machine has been initialised.
Why is my thermal printer skipping labels?
The cause of a Zebra printer skipping labels is usually due to the printer not being fully calibrated or that your driver settings are not set properly for the label size that you are using. Calibrating ensures the correct and consistent positioning of the label in the printer, and the print on the label.
How do I reset my Brother P-Touch label maker?
How do I reset my Brother P-touch Cube?
To reset the machine to the default settings,
- Turn off the P-touch.
- While holding down. and [R], turn the P-touch back on.
- Release. and [R]
How do you troubleshoot a label printer?
The first thing you should do when your label printer is acting up is: check all the hardware! Open the printer. Make sure there is paper, with the label side facing up. Reset the paper, close the printer and hit the feed button, just to double-check!