How do I reprogram my Audi remote?
Audi Keyless Remote Programming Instructions
- Insert your valet key into the ignition of the Audi. Turn the key to “ON.”
- Close the driver’s door while standing outside the car. Insert your ignition key into the door lock.
- Press any button on the remote and watch for the lights to flash.
How do you program a 2002 Audi a4 key fob?
PRESS and HOLD the LOCK and UNLOCK buttons for 4 seconds on the first remote to be programmed. REPEAT Steps 1-2 with EACH remote to be programmed to the vehicle. INSERT key into the Ignition and TURN the Ignition switch to the OFF position. TEST all remotes.
How do I program my Audi a4 remote key?
Press the unlock button on your key fob and hold it. While you hold the unlock button pressed, insert the key into ignition position II. Continue to hold the unlock button pressed for three seconds and then remove it. Your keyfob should be programmed now.
Can you program a used Audi key fob?
Hi there. You could reprogram a key fob to a different vehicle as long as the key is the same for the vehicle. In this case, if the key can go into the doors and unlock them, then you would need to do the following: Remove the battery from the key fob and put it back in (unless you put in a new battery)
How do I program my Audi A4 remote key?
Why does my Audi not recognize my key?
the battery inside the remote is dead. the remote itself is broken or no longer programmed to your car. the car battery is low. the keyless operation system is faulty.
How do I reset my Audi A4 remote?
How to Reset Remote Locking on an Audi Car
- Enter your car, close all of its doors, open the driver’s side window and place a key in the ignition.
- Turn the key two clicks to the right to turn the car to the “On” position.
- Press the lock button on the driver’s side door to lock the doors.
Why won’t my Audi recognize my key?
Reasons your car won’t detect the key fob the battery inside the remote is dead. the remote itself is broken or no longer programmed to your car. the car battery is low. the keyless operation system is faulty.
How do I activate Audi keyless entry?
Audi Keyless Remote Programming Instructions Insert your valet key into the ignition of the Audi. Turn the key to “ON.” Close the driver’s door while standing outside the car. Insert your ignition key into the door lock. Press any button on the remote and watch for the lights to flash.
How do I program a new key fob without original?
How to program a key fob
- Replace the batteries inside the key fobs.
- Get inside the car.
- Turn on the ignition.
- Press the lock button on the remote key.
- Listen for a Lock Sound.
- Programming additional remotes.
- Turn off the ignition.
- Step out from your car and test the result.