How do I reset my Bonaire evaporative cooler?
How to Reset a Bonaire Comfort Control
- Turn the power switch on your Bonaire Comfort system “Off” and immediately turn it back to the “On” position.
- Press and hold the “Heat/Cool/Fresh Air” and the “Off” button at the same time.
- Change each digit using the directional keys below the power button.
How many windows do you need to open with evaporative cooling?
Open the windows or vents on the leeward side of the house to provide 1 to 2 square feet of opening for each 1,000 cfm of cooling capacity. Experiment to find the right windows to open and the correct amount to open them. If the windows are open too far, too much hot air will enter.
Why is my Bonaire evaporative cooler blowing warm air?
Check the pads—Many times a problem with the absorbent pads causes a swamp cooler to blow warm or hot air. Over time the pads lose their absorbency and don’t hold enough water to make the evaporative process work efficiently.
What is Bonaire thermo mode?
In manual control you can operate in thermo, economy, boost or fan mode and operate zones. THERMO MODE. In THERMO mode, the Heater will run at an output power level as. required to achieve the requested comfort level. To use the THERMO.
How often should evaporative cooler dump water?
An evaporative cooler should dump water every six to 12 hours if it has a dump-style drain valve. It should also dump when it turns off. The minimum standard for dumping water is once every 24 hours.
Does evaporative cooling work on hot days?
Evaporative coolers can be very effective on hot days, just as long as they are dry hot days. On those sweltering hot humid days, it’s best just to run the fan only inside or you’ll have a steam room inside – the air conditioning industry doesn’t call evaporative coolers ‘swampies’ for no reason.
How can I make my evaporative cooler work better?
5 Ways to Optimize Your Evaporative Cooler’s Performance
- Choose the Right Time of Day.
- Clean and Replace Cooling Pads As Needed.
- Keep Your Unit Clean.
- Maintain the Correct Water Level.
- Run the Unit Smarter Instead of Harder.
Do you have to leave windows open for evaporative cooling?
For an evaporative air conditioner to work effectively, some windows or outside doors must be open, or some other form of ventilation provided. This is to allow the hot air to escape outside of the building.
How Far Should window be open for evaporative cooling?
Open the windows or vents on the leeward side of the house to provide 1 to 2 square feet of opening for each 1,000 cfm of cooling capacity.
Do I leave doors open with evaporative cooling?
How much water should come out of an evaporative cooler?
Evaporative coolers use both electricity and water. How much water is used depends on the humidity of the day and the fan speed that the unit is set to operate on. A portable unit might use up to 4 litres per hour while a central system could use as much as 25 litres per hour.
How often should an evaporative air conditioner dump water?
every 6-12 hours
If your evaporative cooler has a dump style drain valve, the water will be dumped every 6-12 hours (depending on what your coolers setting is) and then again after it has been turned off. This controls the quality of the water that is being used. Your evaporative cooler may have a leak.
What happens if you fail to install a Bonaire evaporative cooler?
Failure to do so will void all guarantees beyond statutory and legal requirements. Page 2 OOLER Introduction BONAIRE ® Thank you for purchasing a quality Bonaire Evaporative Cooler. We care about your safety and would ask you to spend a few minutes reading these simple instructions before installing or operating this product.
What is a Bonaire swamp cooler?
A water line also connects this unit to its shallow bottom reservoir. In the case of evaporation, a simple float valve is used to control the addition of more material. In contrast to expensive and complex air conditioners, Bonaire swamp coolers provide cooling without using a refrigerant.
What are the spare parts of a Bonaire indow ooler?
ONAIRE INDOW OOLER Spare Parts BONAIRE ® Description Part Number Filter Retainer Clips 6280134SP Louvre Assembly 6280103SP Filter Pad Set 6280116SP Motor Mounting Brackets 6282006SP Motor 6281610SP Fan Retaining Clip 6280804SP 6280806SP Control Knob 6201609SP Switch 904322SP Capacitor 6280133SP Float Valve Assembly…
What is an optional winter cover for a Bonaire indow oiler?
ONAIRE INDOW OOLER Wiring Diagram BONAIRE ® Accessories Winter Cover Inside View. Optional Winter Cover Instructions The Durango optional winter cover has been Location Fin. designed to provide you with a simple method to seal the unit from winter draughts.