How do I reset my Samsung Washer board?
Perform a network reset
- Hold Smart Control until AP displays (about 3 seconds).
- Hold Temp until OK displays (about 7 seconds). The display will then go back to AP.
- Turn off the washer. The next time you try to connect something to the washer, the Wi-Fi and network information will be refreshed.
Why will my Samsung Washer turn on but not start?
If the electrical outlet is receiving power, but the washer won’t start, the power cord might be defective. However, this is very rare. To determine if the power cord is defective, use a multimeter to test it for the cord for power. If the power cord is not getting power, replace it.
Is there a reset button on a Samsung washer?
The easiest way to reset your Samsung front load washer is by turning off the machine and turning it on again. The other technique of resetting it back to default settings is by resetting the circuit breaker (this works for most Samsung front load washer models).
Why is my Samsung washing machine not working?
Check that the door is closed properly and your washer is plugged in. Ensure the water faucets are on open and press the start/pause button. If these aren’t the problem then there may be an issue with the fuse – in which case you need to reset the circuit breaker. Any other resolution will need a qualified engineer.
Why is my Samsung Washer just blinking?
Samsung washer spin light blinking For the most part, this is due to improper installation of the washer or failing to balance the load. For that reason, work on balancing the load size (as explained earlier) and ensure the selected type of cycle matches what you’re washing.
What are the Samsung washing machine error codes?
Samsung Washing Machine Error/Fault Codes
- 5E/SE – Draining Problems.
- 4E – Not Enough Water Entering Machine.
- dE or DC – Open Door.
- UE – Unbalanced Load.
- 3E – Faulty motor tacho.
- bE – Motor triac short error.
- OE – Too much water in machine.
- LE – Water Leak.
How do you troubleshoot a washing machine?
Washer Troubleshooting Guide
- Check that the washer is plugged in securely.
- Check the circuit breaker or fuse box.
- Test the outlet for current.
- Check that the water supply valves are turned on.
- Inspect the filter screens.
- Test for overheating.
- Test the water level switch.
- Test the timer control.
Can you hard reset a washing machine?
If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved.
Why is my Samsung washer blinking and not working?
2. Samsung washer spin light blinking. For the most part, this is due to improper installation of the washer or failing to balance the load. For that reason, work on balancing the load size (as explained earlier) and ensure the selected type of cycle matches what you’re washing.