How do I sync my PetSafe collar to my transmitter?
Put boundary switch on transmitter in the ‘high’ position. Turn the boundary control dial on the transmitter to position 4. Standing within 1.5 – 3 metres of the transmitter, re-insert the batteries into the receiver collar(s). Test the boundary by walking out into the safe zone until your receiver responds.
How do I pair my new PetSafe collar?
Press the button on an angle to see the upper half of the button while holding. Press and hold the upper left button on the remote to pair the collar. The collar will flash five times and then begin beeping to confirm it is paired. Release the button and test to confirm it is properly paired.
Why is my wireless PetSafe collar not working?
But if you just changed it and it’s not working as intended, it may need resetting. Reset the collar by removing the battery and holding down the correction level button for about 10 seconds. Then put the battery back in and switch the collar on. Make sure that the indicator light is on.
How do I know what PetSafe system I have?
You will be able to identify your system using the model numbers on your base unit, collar or product packaging….You can find the model numbers:
- on the bottom of the base unit.
- under the front cover.
- on the back of the base unit.
Why is the red light flashing on my PetSafe collar?
If you have started to see a red flashing light on your pet’s Computer Collar unit, your Power Cap battery may need to be replaced. You can order replacement batteries online, from your local dealer, or by calling 1-800-824-3647.
What collars are compatible with PET stop?
This Pet Stop receiver is compatible with most brands – PetSafeâ, Invisible Fenceâ, Dog Watchâ and Dog Guardâ. Our Elite SW collar weights just 1.3 oz. and has a patented correction scheme that adapts to your pets specific behavior. The Elite SW can be programmed to work with some Pet Containment transmitters.
How do I reset my petsafe collar?
Reset your collar Press and hold the power button for 10 seconds to reset the collar. The collar turns off, then flashes green and beeps to indicate that it has been reset. Release the button. Press and hold the button on the collar until a beep is heard and the light flashes green indicating that the collar has power.
Why is my PetSafe collar beeping but not shocking?
If you do not feel a shock, then there may be a problem with the receiver collar. Make sure you touch both points on the receiver at the same time when you hear the collar beeping. It will tell you definitively that the fence is or is not working.
How do I reset my PetSafe wireless collar?
Press and hold the button on the collar until a beep is heard and the light flashes green to turn the collar on. Press and hold the power button for 10 seconds to reset the collar. The light turns red and the collar turns off.
What collars work with PetSafe in ground fence?
Yes, a few of the PetSafe® In-Ground™Fence Extra Receiver Collars will work with this system. They include the PUL-275 Deluxe In-Ground UltraLight(TM) Receiver Collar, the PRF-275-19 Stubborn Dog In-Ground Receiver Collar and the PIG00-10778 Elite In-Ground Little Dog Receiver Collar.