How much is a trailer for a jon boat?
How much do Jon boat trailers cost? You can pick up a cheap kit on Amazon for between $500 and $800.
How should a jon boat sit on a trailer?
Set boat on trailer while maintaining no less than 2″ gap between keel and tongue plate cover. The end of the bunks/rollers should be flush with transom and the boweye should reach the winch post. If this is so, the rear pivot should remain in the A-position.
How long is a jon boat trailer?
Aluminum Jon Boat Trailers
| Model | Capacity | Overall Length |
|---|---|---|
| VAB-1025 | 1025 | 15’5″ |
| VAB-1325 | 1325 | 18’1″ |
How wide is a jon boat trailer?
Specifications
| Model | JBT-900 |
|---|---|
| GVWR (lbs) | 1,000 |
| Weight (lbs) | 200 |
| Width (Overall) | 4′ 9″ |
| Width (b/w Fenders) | 3′ 7” |
Should your boat be level on the trailer?
When you tow a boat trailer – or any trailer for that matter – the trailer needs to be as level as possible before you take off for your destination. This is because the weight needs to be evenly distributed across the trailer axles to allow for proper handling and tracking.
How high should my boat be on a trailer?
A boat on a trailer is 2 to 2.5 feet taller than the “bridge clearance” listed on your manufacturer’s specifications. For example, a 22-25 feet boat will usually be above 10 feet tall on a trailer, with some exceptions.
How fast can you pull a jon boat trailer?
The National Association of Trailer Manufacturers says boat trailer tires have a maximum speed rating of 62-68 mph, so keep this in mind when driving on interstates.
Can a boat trailer be converted to car hauler?
I did this about 9 years ago took a single axle boat trailer and turned it into a tandem axle car hauler. It was a lot of work but doable. It will be cheaper to buy one if you count your man hours. enough to take everything you have.
Will a 12 foot jon boat fit in a truck bed?
I hauled a 12′ jon in my short bed (6.5′ bed) truck this year. worked great, I could do it alone no problem.
Will a jon boat fits in truck bed?
You can put a jon boat in the back of a truck in its bed as long as your jon boat’s stern doesn’t stick out too far (usually less than 4 feet). Most truck beds will range between 5 and 8 feet and jon boats are usually 8-20 feet in length.
How much weight can a 16 foot jon boat hold?
Weighing an average of 360 pounds (163 kg) excluding an engine and with 30 to 35 HP, a 16 feet (5 m) long Jon boat has an additional 990 pounds (450 kg) of carrying capacity. It can effortlessly accommodate four people and gear and sail at 35 mph (56.5 km/h).
Should a boat sit level on a trailer?
Keeping it Level When you tow a boat trailer – or any trailer for that matter – the trailer needs to be as level as possible before you take off for your destination. This is because the weight needs to be evenly distributed across the trailer axles to allow for proper handling and tracking.
How deep should my boat trailer be in the water?
It should be just about as deep as it was when taking the boat off, and in most cases, about two-thirds of the trailer will be submerged while one-third remains out of the water. Don’t submerge the trailer too deep, or the bow of the boat may float over the bunks and go off to the side.
How fast can you drive with a single axle boat trailer?
How to build a jon boat trailer?
How to Build Your Own Jon Boat Trailer 1 Measure the length and width of the jon boat. 2 Cut off two lengths of galvanized square tubing equal to the width of the axle mounting pads. 3 Cut off two 2 1/2-foot lengths of the square tubing to support the two cross-members above them and attach the axle spring mounts below them.
Can you build a wooden jon boat in 2 weeks?
Building A Wooden Jon Boat In 2 Weeks! Here’s a story we enjoyed hearing. It all started when this YouTuber suddenly found himself with two weeks to spare – so he decided to build a boat! Enterprising character that he is, he started by going online to get an idea of how his project would look, and then he just went ahead and did it.
Can you add a cabin to a jon boat?
If you have a Jon boat but you want to want to give it a little upgrade by adding a cabin, this is the video for you because, as you can see, that’s exactly what this YouTuber did with his.
How do you measure a jon boat trailer?
Measure the length and width of the jon boat. Add four feet to the length from the rear of the motor if it has one to the front of the bow handle. This will be the trailer’s overall length. The one-piece galvanized steel tube that comprises the backbone of the trailer needs to be this length.