Is there a reset button on Hayward pool heater?
The heater can be manually reset using the keypad by cycling the MODE button through “STANDBY” and back to the original operating mode (“POOL” or “SPA”).
How do you reset a pool heater breaker?
How to Reset the Lockout on a Pool Heater
- Reset the breaker for the electrical circuit to the pool heater by flipping the breaker switch to the “Off” position and then to the “On” position.
- Remove the cover on the digital control panel.
- Press the “Mode” button, and cycle to the “Standby” setting.
Why is my electric pool heater not turning on?
Check the Filter The most common cause of swimming pool heaters refusing to start up is a dirty swimming pool filter. A dirty filter or pump basket can restrict the water flow so much that the heater simply can’t work.
What does the code if mean on a Hayward pool heater?
Ignition Failure
Keypad Failure. “IF” – Hayward Pool Heater Fails to Ignite: the most common reason for this problem is insufficient gas supply. The Hayward heater LED display will show a diagnostic fault code of “IF” which stands for Ignition Failure.
How do you troubleshoot a Hayward heater?
I hope that these charts are helpful in solving your Hayward pool heater problems….Hayward Pool Heater Troubleshooting.
| PROBLEM PRESENTING | PROBABLE CAUSES | POSSIBLE SOLUTIONS |
|---|---|---|
| IMPROPER VENTING | INSPECT CORRECT EXHAUST | |
| BLOCKED HEAT EXCHANGER | CLEAN HEAT EXCHANGER | |
| BLOCKED BURNERS | CLEAN DEBRIS ON BURNERS | |
| PILOT OUTAGES | LOW GAS PRESSURE | INCREASE PILOT GAS PRESSURE |
Why does my pool heater not ignite?
If the pilot won’t light, the gas pressure could be low, the air supply may be poor, or the heater may not be venting properly. Check the gas pressure, and adjust it if necessary. Then check all the vents to make sure they’re not blocked. If any of them are, simply remove the blockage, and try lighting the pilot again.
How long do Hayward pool heaters last?
7-10 years is the average life expectancy of a pool heater.
How do I get my Hayward heater out of bypass mode?
Press the Mode button to place the heater in Standby Mode. Hold the Down Arrow and Mode buttons simultaneously for 3 seconds for Bypass operation. “bo” will be displayed on the screen.
What would cause pool heater to not ignite?
The most common cause of swimming pool heaters refusing to start up is a dirty swimming pool filter. A dirty filter or pump basket can restrict the water flow so much that the heater simply can’t work.