Is there a way to bypass a thermocouple?
Realistically, you have just disabled the thermocouple, but you can also reach in and unclip it from its holding bracket where it meets the pilot light. In most cases it will be held on with a gravity clip, but some are held on with a screw that must be removed with a small screwdriver.
What would cause a propane heater not to stay lit?
When your propane heater’s pilot light doesn’t stay lit, it’s most likely because of a dirty thermocouple, a dirty pilot, and a clogged orifice. The heater will also fail to work, in case it is placed in a windy area – a wind barrier will get the problem solved.
Can you clean thermocouple?
Yes, you can clean a thermocouple, but the task must be done with a light touch. Remove the thermocouple from the process assembly, using a steel wool or emery cloth, lightly clean the tip removing any build up. Cleaning a thermocouple is not a fix for an issue, such as inaccurate readings.
Why does my pilot light go out when I release the pilot light knob?
If you’re able to light the pilot light, but it goes out when you release the control knob, the thermocouple probably needs replacing. The thermocouple is a safety device that shuts off gas flow if it senses the pilot light is out, but when damaged it loses its regulatory ability.
What causes a thermocouple to fail?
After enough time, metal fatigue can cause a thermocouple to break. Thermocouples that are regularly exposed to extreme heat stress or extreme conditions are more likely to go through metal fatigue. If thermocouples start to give out unusual readings, it may be suffering from metal fatigue.
Can you clean a thermocouple?
What happens when a thermocouple goes bad?
The thermocouple can do this because, in its probe, it contains two different metals, and a voltage is generated when one of them is heated. This is the result of a phenomenon known as the Seebeck Effect. Nothing lasts forever, and when the thermocouple wears out, the pilot won’t stay lit and your appliance won’t work.
Can a thermocouple be fixed?
Thermocouples are designed to detect a pilot light’s loss of heat and close the gas valve to prevent a gas leak. Replacing a thermocouple is a relatively easy fix that can take less than two hours.
How do you know if your thermocouple is bad?
After about a minute, when you’re sure the probe has gotten hot, place one lead on the shaft of the thermocouple and the other lead on the connector. If the reading is less than 25 millivolts, the thermocouple is bad and needs to be replaced.
What are the signs of a bad thermocouple?
If you can’t get the flame to light at all, and you’re sure the gas is on, there’s probably an obstruction in the pilot tube. If the flame lights and goes out when you release the gas control knob after holding it in for the recommended 20 to 30 seconds, that’s the sign of a thermocouple malfunction.