How do you reset the change oil light on a 2003 GMC Yukon?
2003-2015
- Turn ignition switch to ON position with engine off.
- Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key.
- Change Oil lamp will flash for 2-10 seconds while it resets.
- Once it stops flashing, the maintenance light reset is complete.
How do I reset my truck after an oil change?
Oil Change Indicator Reset
- Switch the ignition on.
- Fully press the accelerator and brake pedals at the same time.
- Keep the accelerator and brake pedals fully pressed.
- After three seconds, a message displays confirming the reset procedure is in progress.
How do I clear my change oil soon light?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How do I turn off the change engine oil soon?
Maintenance – Oil Change Indicator Reset
- Switch the ignition on.
- Fully press the accelerator and brake pedals at the same time.
- Keep the accelerator and brake pedals fully pressed.
- After three seconds, a message displays confirming the reset procedure is in progress.
Why does my car still says change oil after oil change?
The oil pump may not be circulating enough oil to keep the engine’s parts lubricated and functioning properly, which can in turn cause multiple engine issues. Although receiving oil changes at regular intervals should prevent this problem from occurring, parts do wear over time.
Why is my check engine light on after oil change?
Why Is the Check Engine Light on After an Oil Change? Seeing a check engine light soon after an oil change typically happens because the oil dipstick is not fully seated or fitting the oil filler cap backways.
How do I reset my 2003 Silverado?
2003 CHEVROLET Silverado Maintenance Light Reset Instructions
- Turn the ignition to run (one position before starting engine).
- Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
- If the Change Oil Soon light flashes the system is resetting.