What is the width of a Dana 44?
These Dana 44s are an almost perfect swap for the rear of any TJ, YJ, XJ, ZJ, WJ, or even a KJ. At 60 3/4 inches wide, this axle is almost the same width as a TJ (61 1/2 inches, wheel-mounting surface to wheel-mounting surface).
Are all Dana 44 the same width?
The Dana 44 has been offered in both high- and low-pinion, with centered and offset pumpkins. Factory axleshafts ranged from 10-spline through 32 with diameters from 1.175-inch up to 1.41-inch.
How big of a tire can you run on a Dana 44?
36-inch
We often get asked how big a tire a Dana 44 can hold up to. That’s not an easy question to answer. Several factors, such as terrain, vehicle weight, driving style, and engine output, come into play. However, as a very general rule, a 36-inch tire is about the limit for a Dana 44.
How wide is a Dana 60?
Differences between the front Dana 60s:
| OEM | Years | width (wms-wms) |
|---|---|---|
| Chevy | 79-87 | 69.5″ |
| 88-91 | 69.5″ | |
| Dodge | 79-91 | 67.5″ |
| 92-93 | 67.5″ |
What is a full width axle?
A full width axle is an axle out of a larger truck such as a Chevy, Ford, or Dodge ½ ton, ¾ ton or 1 ton. These axles are much stronger and larger than your stock Jeep axles. Swapping these axles into the rear of your Jeep CJ or Jeep YJ is pretty straight forward.
What’s the difference between a Dana 44 and a Dana 60?
The Dana 44 axles use u-joints that measure 2.18 inches from snap ring to snap ring. The Dana 60 axle uses u-joints that measure three inches from snap ring to snap ring. The Dana 60 has a larger ring gear, larger axle tubes, larger axle shafts, and overall is much stronger.
Are Dana 44 axles limited slip?
True-Trac limited slip for Dana 44 rear with 30 spline axles. fits 3.73 and down. The True Trac limited slip uses a worm-gear design to bias torque from one tire to the other, providing extremely smooth operation.
How wide are stock Jeep axles?
This assembled axle is the stock JK width (65.5 inches), comes with a 35-spline ARB Air Locker and 5.38:1 gears. This specially-configured ProRock 60. This assembled axle with extra width (68.5 inches), comes with a 35-spline ARB Air Locker and 5.38:1 gears.
How wide is a GM 10 bolt rear end?
The 8.5-inch 10-bolt rearend was used in cars and trucks over a wide range of years. It first appeared in 1970 production cars as a corporate replacement for the 8.2-inch 10-bolt rearend. It was used in different models by all GM divisions – with the exception of Cadillac.
Are Dana 60 wider than Dana 44?
The Dana 44 came with axle tubes anywhere from 2.5 to 3-inch in diameter. The Dana 60 only came with one axle diameter of 3.125 inches, which is pretty big. Those larger axle tubes help strengthen the housing, but also make room for larger axle shafts.